fbekholden.com

So who owns the black beast now

Boorowa hotrod wrote:Hi mate one fat EK just striper my fb it will be V8 four link and Torana f/e when I get sum picks will post them

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
welcome to the forum mate...we would love to see your project ......start a new thread in this section and tell us a bit about your build .......Fingers

Hi
I am stating to build a FC ute in Darwin and was told to fill out my TAC paper work asap. I said to Wilko at fishermans wharf about won'ting to build it like the black EK (yours). Do you have any tips?
Thanks
PS I drive a FB ute as well.

Some one must know where the black beast is lurking

Just for fun, let's make up some possible scenarios for it.

I heard Steve Jackson bought it and plans to 'restore' it back to original

Mick heard it was honey beige originally.. wasn't happy that it wasn't modified enough and is currently 2 dooring and chopping the roof?



Cheers
Nathan

Thats funny I heard it was getting a FJ front grafted on to it

He swapped it for an AU Falcon.

Maybe he's getting old and can't handle the power and is to embarased to admit it
Come on where is she hiding

ITS SHMEAGAIN its hiding at my place he sold it to me an told me to keep it on the down low

shmeagain wrote:ITS SHMEAGAIN its hiding at my place he sold it to me an told me to keep it on the down low

Did u sell the humpy with the 400small block to pay for the black beast

I have it on good information that it was sold to a Chinese Goverment so they can dismantle it and plan to reproduce it with a massive 1.3 litre daewoo power plant and niva lada running gear ......V8EK4us will then be melted down and used in the manufacture of the said vehicles .......its true ........... ...Fingers

And on it goes

Gary
Did u have any problems with your engine bay paint blistering from your log headers
Also can you tell me how much clearance did you have from the paint work
I wrapped my log headers with heat wrap and the paint blistered even up to 10 cm away

My log headers are made out of stainless do u think I would be better off making mild steel and ceramic coating them

I saw it in Tasmania with a Commodore grafted on the rear...