fbekholden.com

175 on a six inch rim won’t fit!


Sent from my iPhone using Tapatalk

6.50 x 13” cross ply just fits.


Sent from my iPhone using Tapatalk

Thanks for that advice. I'll see if I can get 175s. The ones I was quoted on are Maxxis with a whitewall on one side. I'm thinking white wall on sooky sedan and plain side out on tough nut ute. Obviously non- directional.

I have a 155/75/13 spare and it juuuuuusssstttt fits ........

or just make a lift up hatch and cut the rearmost support bar out - works a treat and can still use the original spare clamp - mine are 185's on 4.5 inch steel rims and no-where near fitting

You hot rodders I don’t know. The rear support is already missing Rob but you’ve got me thinking now. All the good work I’ve done refurbishing the floor would then be on show. Maybe I will.


Sent from my iPhone using Tapatalk

Found this today Clay, circa 1970, me behind the wheel. Something special about FB/EK. (Sorry to take the focus off the ute for a sec )

Sent from my SM-G975F using Tapatalk

That’s s beauty kym


Sent from my iPhone using Tapatalk

Thanks Rob, Blacky and Clay. The hatch is a good idea and about the only sensible option if running non original tyres I think. There are some good stainless fold down hatch locks in the boating world that would work perfectly on a wooden tray.
Rob, no problems running 185s on 4.5 inch rim?

Hi Brett,
I have been running 185's (70 profile) by 13" on my ute for a while and the same on my sedan using original rims no probs. Similar to Blacky I have a narrow 13" for the spare. Cant remember actual size but think it would be 165?

Regards
Stephen

Thanks Stephen. I was thinking of going 185 80s as they are the closest to original radius. Cheers

Just been tidying up the tray filling up holes with the mig and bit of filler on the rear end rust repairs so nothing of interest to post. Then when o got home tonight this was waiting:Looks a quality product. $188 delivered from Retro Spares Auto Cables at Eltham.


Sent from my iPhone using Tapatalk

I’m going to drill the badge holes and 2k etch the inside prior to fitting to frame. Seen this posted somewhere but can anyone with an original tailgate tell me the measurement from bottom lip to badge centre please? Otherwise I will strip the one off the van which appears to have been filled and painted over.


Sent from my iPhone using Tapatalk

Never mind. guilty of asking unnecessary questions.
It’s s bit tempting to use this tailgate off the van now I’ve got it down.


Sent from my iPhone using Tapatalk

But no this one has the usual grubby little secrets


Sent from my iPhone using Tapatalk