seatbelt mounts

If it doesn't fit below then post here and see if another FB EK fanatic can help you out.

Moderators: reidy, Blacky

Post Reply
fatfbwagon
Posts: 26
Joined: Tue Apr 14, 2009 8:12 am
State: NOT ENTERED
Location: lakehaven

seatbelt mounts

Post by fatfbwagon »

hey guys spoke to my engineer yesterday an he told me i need 150 x 20 x 12mm steel to put on the pillars for the seatbelt mounts. he mentioned it has to slip inside the pillar. just wondering if anyone else has done this if they could send me some pics or advice on how to do it. do i need to cut into the pillars to get the steel inside them. thanks wayne
love is sweet, love is golden, love should be made in an fb holden
Top
matches
Posts: 870
Joined: Mon May 26, 2008 6:08 pm
State: NOT ENTERED
Location: port macquarie, nsw

Post by matches »

check this out, my engineer told me this was fine when i showed him a printout of this page http://www.wescoperformance.com/3-point ... -door.html
luke.
Top
User avatar
careyman
Posts: 110
Joined: Wed Feb 18, 2009 1:33 am
State: NOT ENTERED
Location: Hoppers crossing

Post by careyman »

maybe sticky.. :?
FB's=Friggin Bewdyful
Top
EK JAY
Posts: 1888
Joined: Sat Mar 17, 2007 8:25 pm
State: NSW
Location: Sawtell

Post by EK JAY »

:) If your using retractables im pretty sure Malcom
and Garry (V8EK4US) did this to there cars check out there threads
EK JAY SINCE 1990
Top
Post Reply

Return to “General sharing advice and experience”