Need cylender head rebuild.

dave68 · Post by **dave68** » Thu Sep 10, 2009 8:08 pm

Does anyone know of a good cylender head rebuilder as #6 valves are F%$#^D.... I need them to be ground and reseated so I am after someone that can be trusted in Sydney. Any one please.
Kinda urgent as well.
Thanks.

Cal · Post by **Cal** » Thu Sep 10, 2009 9:04 pm

I had a fair few heads done at some place in Kingsford some years back. Forget the name

Very good head jobs.............so to speak. Think it's shut now

Finny · Post by **Finny** » Thu Sep 10, 2009 10:21 pm

Dave, you should know you can't trust anyone in Sydney

Had mine done local in Brisbane, very happy.
Could be a bit far ?

Get unleaded done while your at it.

Cal · Post by **Cal** » Thu Sep 10, 2009 10:30 pm

I can name one very well known head place in Sydney NOT to go to.

Had some &*#@ V8 heads sent there by the bloke rebuilding my motor. The valve stem seals shit themselves after a couple of thousand km's

FB MAD · Post by **FB MAD** » Fri Sep 11, 2009 9:42 am

Have a look in the list of suppliers and services, might find someone here that can rebuild the head.

http://www.fbekholden.com/forum/viewtopic.php?t=587

Maybe try Terry ( Dr Terry on the forum ) at Bebco Automotive 26 Alexander st, Auburn ph 02 9644 2888.

Nice bloke and knows his Holdens!!

dave68 · Post by **dave68** » Fri Sep 11, 2009 6:55 pm

Thanks guys. I ended up getting one from Melbourne, exchange 2 yrs warrantee and all that, not too bad $450.

parisian62 · Post by **parisian62** » Fri Sep 11, 2009 9:29 pm

Dave...give Russell at Dominator Engines a call at 22 Guernsey St Guildford 9681 3462...they are just down the road from where the Club meets...

Stewart