LS1EK
-
WesternWagon
- Posts: 1084
- Joined: Wed Jul 07, 2010 6:33 pm
- State: WA
- Location: Mandura WA
Re: LS1EK
look Killa 
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Member : Holden Car Club WA.
:ASRF Member
: Secretary FB/EK holden Club of WA.
:ASRF Member
: Secretary FB/EK holden Club of WA.
Re: LS1EK
Some more progress, one side of the engine bay all smoothed out. Will be going for a satin black finish.
- Attachments
-
- IMG_3710.jpeg (3.59 MiB) Viewed 92 times
-
- IMG_3711.jpeg (3.78 MiB) Viewed 92 times
-
- IMG_3740.jpeg (3.45 MiB) Viewed 92 times
Re: LS1EK
Been scratching my head on how I was going to fix the fire wall where I stuffed it from welding on the inside.
In the end the solution was easy, I just made a new section and put it straight over the top. Plugged weld a few spots around the edges and glue the middle sections with silaflex.
In the end the solution was easy, I just made a new section and put it straight over the top. Plugged weld a few spots around the edges and glue the middle sections with silaflex.
- Attachments
-
- IMG_3748.jpeg (1.92 MiB) Viewed 49 times
-
- IMG_3749.jpeg (2.73 MiB) Viewed 49 times
-
- IMG_3751.jpeg (3.35 MiB) Viewed 49 times
Re: LS1EK
Thats the trick,
You can tell your engineer that is double plated to increase the strength, should get some points there.
I'm assuming that black is epoxy primer you will rub back once the painting starts ?
Keep going mate your on the home stretch.
Greg
You can tell your engineer that is double plated to increase the strength, should get some points there.
I'm assuming that black is epoxy primer you will rub back once the painting starts ?
Keep going mate your on the home stretch.
Greg
So many cars so little time!
