Torana front end

[oz_ek]

Ek sub frame.JPG (136.98 KiB) Viewed 5402 times

Torana sub frame 001.jpg (158.13 KiB) Viewed 5402 times

Torana sub frame 002.jpg (160.34 KiB) Viewed 5402 times

Thinking about fitting a Torana front end to my EK... looking at the above drawings of the EK and Torana sub frames it would appear the Torana has some degree of 'built in' caster ?

[ehsv6]

http://forum.fefcholden.club/index.php?topic=13343.0

Have a look at this if you haven't already.

Cheers Keith

[oz_ek]

http://forum.fefcholden.club/index.php?topic=13343.0

Have a look at this if you haven't already.

Cheers Keith

Thanks for the link Keith......I read that thread sometime ago, from memory there isn't any info regarding the original Torana FE mounting angle .

[EK283]

Yes indeed there is angle on the Torana front body whilst the FB EK subframe has zero angle.

I have installed a Torana front end in my EK and you have to section it to obtain the correct caster angle.

Regards Greg

[gazza]

I put one in my fj holden and used the standard rubbers for the fj the two back rubbers are thicker than the front ones which angles the front end down at the back. cheers Gary.

[oz_ek]

Torana chassis rail 002.jpg (94.57 KiB) Viewed 5327 times

Thanks for the replies Gents.......I've tracked down a Torana rail similar to the one above, it should provide the info I'm looking for.