Paddy’s HT Holden Belmont ute

gpi · Post by **gpi** » Tue Apr 21, 2020 4:39 pm

HEI distributor installed

gpi · Post by **gpi** » Tue Apr 21, 2020 4:50 pm

One for Clay: Jim Pollock shaped Swallow Tailed Mini Gun Rip Curl board circa ‘75.

Errol62 · Post by **Errol62** » Tue Apr 21, 2020 7:24 pm

Nice. Wish I still had my first board. Was a 1972 Don Burford, heritage green bottom and rails and orange deck.

I’d rather have a HKTG though.

FB ute fixer upper, EK van on rotisserie

gpi · Post by **gpi** » Fri Jul 31, 2020 6:20 pm

Errol62 · Post by **Errol62** » Sat Aug 01, 2020 12:47 am

Very good original condition by the look

FB ute fixer upper, EK van on rotisserie

Errol62 · Post by **Errol62** » Sat Aug 01, 2020 10:03 am

You got the right carby for that filter Patrick?

FB ute fixer upper, EK van on rotisserie

gpi · Post by **gpi** » Sat Aug 01, 2020 1:16 pm

No point, getting reefed out for something with a couple more cylinders...

I noticed this looked crap

So some AquaKlean and elbow grease later

Just need to add 2 pots and it’ll be good

Errol62 · Post by **Errol62** » Sat Aug 01, 2020 2:16 pm

Column trimatic please

FB ute fixer upper, EK van on rotisserie

gpi · Post by **gpi** » Sat Aug 01, 2020 2:26 pm

Column 4L60E

Errol62 · Post by **Errol62** » Sat Aug 01, 2020 3:50 pm

HT shift at least. Tunnel mods?

Sent from my SM-G973F using Tapatalk

gpi · Post by **gpi** » Sat Aug 01, 2020 4:32 pm

i have three things:

1. Cutting wheel
2. Welder
3. Will

EK283 · Post by **EK283** » Sat Aug 01, 2020 6:06 pm

gpi wrote: ↑Sat Aug 01, 2020 2:26 pmColumn 4L60E

Then go the CHEV 350,

More power, more fun, less fuss !!!!

Greg

gpi · Post by **gpi** » Sat Aug 01, 2020 6:23 pm

a truck motor would do

FireKraka · Post by **FireKraka** » Sun Aug 02, 2020 9:45 am

V8 TH700R4 SBC bolt pattern to block manual cable kick down no electronic shift like 4L60E and overdrive

Neil's two cents worth.

Errol62 · Post by **Errol62** » Sun Aug 02, 2020 10:52 am

.

Sent from my SM-G973F using Tapatalk

fbekholden.com