Yolk change over

[Eeek]

I got a 3.36 to go in my ek but the yolk is different and cannot attach to the tail shaft. I went to change over the yolks but they dont match one has coarse spline and one has fine spline. Any suggestions on a correct yolk or do you need to change the tail shaft to suit the 3.36

[EK283]

EeeK,

The diff flanges could be different as you say, you really only need to change the uni joint from the cap style on the old diff to a round cup style with u bolts.

Hope this makes sence and helps.

Regards Greg

[choppedfan]

EeeK,

The diff flanges could be different as you say, you really only need to change the uni joint from the cap style on the old diff to a round cup style with u bolts.

Hope this makes sence and helps.

Regards Greg

And the later uni's are cheaper

Mick