Painted flash line 'HOW TO" part 2.0...
In this bit we attack the 'chrome strips' and mask up all the laced inner & in fine line tape the outside of the strips..I've opted for 1" upper strip & 1/2" lower ..I always thought that the last version had an over-thick lower strip size..

( a note here..I pulled the lower of the flash at a more 'rounded back' shape this time around also )
Once I was happy with the gap sizing between the tape it was just make a rounded to sharp shape on ends of the strips ..did this with masking tape only on the smaller strip with a stencil knife. Then paper the whole area off ready for paint...
Next was to mix a nice micro metallic silver and paint it on...

.. now I'm leaving the silver to dry for about two hours and next add the detail in air brush...
stay tuned....
Scotty.