Hey guys,
My EK has a rubbing noise, only under load.
It seems to be coming from the rear of the car.
So I'm leaning towards a diff issue,
But not totally sure as it sounds like a worn bearing.
Any suggestions??
Thanks in advance
KD
Rubbing noise under load???
-
- Posts: 99
- Joined: Mon Nov 30, 2009 8:19 pm
- State: NOT ENTERED
- Location: Joondalup, WA
Rubbing noise under load???
Karting is cheap.............yeah right!!!!
-
- Posts: 99
- Joined: Mon Nov 30, 2009 8:19 pm
- State: NOT ENTERED
- Location: Joondalup, WA
A rubbing type noise is an unusual noise for a wheel bearing as they tend to rumble when on the way out.Sometimes the diff carrier bearings can sort of give a whirring type noise when starting to go and then tend to the rumble when bad.
If a diff pinion gear to crownwheel gear isn't meshing correctly ( not adjusted right ) or worn they can give a high pitched hum or whirring type noise and depending on what type of adjustment is out they can do it on either run ( loading ) or overun ( backing off the throttle ).
Might be something other than the above, its very hard to diagnose by a written description.
If a diff pinion gear to crownwheel gear isn't meshing correctly ( not adjusted right ) or worn they can give a high pitched hum or whirring type noise and depending on what type of adjustment is out they can do it on either run ( loading ) or overun ( backing off the throttle ).
Might be something other than the above, its very hard to diagnose by a written description.
I can't think what to write here so this will do.