accelerator pedal

mrs ratbox · Post by **mrs ratbox** » Fri Jul 07, 2006 9:49 pm

i've used datsun 1200/120y pedal with a little bit of bending used the same hole as others have mentioned and a xd &*#@ v8 cable when used with a holley whole job from start to finish takes about an hour very easy

HEMI · Post by **HEMI** » Mon Jul 17, 2006 9:16 pm

Here's a pic or two

[/img]

Sammy · Post by **Sammy** » Mon Jul 17, 2006 10:35 pm

neat setup for a strommy!

yeprat1 · Post by **yeprat1** » Tue Jul 18, 2006 5:39 am

thanks for the pic hemi i was actually thinking why didnt speed shops come up with this conversion could u please tell me though what are those attachments u have used there supporting the cable where it joins the pedal thanks troy

stinky · Post by **stinky** » Tue Jul 18, 2006 8:30 am

I might have to give this a try on the FE, it looks like with a bit of "creativity" you could avoid the cable going inside the car altogether.

HEMI · Post by **HEMI** » Tue Jul 18, 2006 9:37 am

The part you are talking about yeprat1 is standard L300, the fitting on the carby is standard choke fitting turned 90 deg.
Looks good if going for a clean simple engine bay and cheap too cost a whole $10