fbekholden.com

not if it isn't leaking - maybe spray a bit of WD-40 or the like in there ??

Happy days, just scraped in with 134 days to go until the Nats

There was a bloke selling wiper bush refurb. kits on both Epay and the FB/EK enthusiasts page a couple of years back - they were about $20 a set from memory

One of the $50 specials I owned was a HK and it used to do the same thing but I never bothered to find out what it was - it could get a bit hairy in Sydney traffic though ...

It's 42 degrees here today, too hot to go looking for car parts - give me a few days mate

With either method I would make a tank a bit bigger than the fuel tank and completely submerse it - you could do a half at a time though if it will fit into something you already have

Either citric acid or molasses

Now the fun part

Have 10 put away for Roger when he gets here mate

Is that factory colours mate ??

The VE pumps have a built in swirl pot and technically won’t give any trouble- while the tank was open we welded bits of flat sheet with a couple of mm gap at the bottom around the fuel pump and the sender unit float

Nice work mate, looking forward to seeing it coloured in

If I had my time again Neil I would mount the pump towards the rear of the tank rather than the front - we did fit baffles to limit fuel surge but I think it would have been better as far back as it can go

Holy snapping duck poop - that has to be a record !!!!!!

Signed up to the forum on 16/07/2006 and first post is today !!!!! 6,752 days !!!!!

Welcome to the forum mate, I am away for a week or so but when I get back if you haven't found one by then I will have a look and if i have one its yours ...