fbekholden.com

Thanks for these Mangus great to see the wifes car.

Hey Tim hope all is well with you and the family long time no see.
I bought the venetian now fitted to wifeys ute not going to paint it as it suits the car in its original state.
The wagon mate the problem is no room for another and there is no way I am going to let any of my cars get wet.
Its now ...

I go to Indonesia every second month for work.The early Holdens are really becoming popular with the young guys of Indonesia a Holden pre HQ is now going for between AU$ 3500 to 6000 in need of medium restoration.
You used to be able to pick them up for 4000 tops running.
Wag62 Mick

Hi guys long time since Iv'e been on, been busy with the rebuild of my 56 chev.
I have located an original rear venetian for the wifes FB ute have tested the fitting and perfect definatly an FB EK ute venetian.
The guy wants AU$200 for it no dings very straight but will need a repaint.
Is this a ...

Sorry been away from the computor for over a week.
Wagon sold to a fellow club member.
And no Tim didn't get a 60 chev bought a 56 instead.
Mick

Thanks Trudie,
Yeah she is beautiful and a great car but have bought an other car (Back to the Chevys) and I don't want to see her sit and deteriate.
Have to get 15k for her.
Mick

Hey Greg,
Spoke to Tim yesterday and he mentioned you were looking for a 61 auto.
I am selling my 62 auto wagon.
If you go onto Tims Queensland sight it is on there under members car Mick.
Unfortunatly I am in Brisbane.
Regards,
Wag62

I'll be there with the wife,
Wag62 Mick.

Hey Guys,
Once again our club run falls on the same date as a major event Greazefest.
I won't be attending the club run sorry.
Wag62 Mick

My son has a worked 202 and 4 speed with a 336 lsd doesn't rev too hard on the highway and has heaps of grunt off the mark tyres are 225/60/13.

My hyromatic grey motor is now running a 355 with 185/80/13 tyres and is perfect all round.

My wifes 3 speed grey is now running a 336 with 205/60/13 ...

All done had to use an oxy.
Poped right out.
Wag62 Mick

Hey guys another pain in the ass.
I'm putting a 336 centre into the FB ute removed the drivers side axle easily but can't budge the passenger side.
Have used a light weight slide hammer and broke it have turned the brake drum around and put 3 wheel nuts on and used it as a slide hammer and still won ...

Hi Guys thanks for all your suggestions it was the rubber clutch hose plenty of fluid going through but the inside of the hose was collapsed.

Also sorry for the late reply to the fix solution Mum died last week pretty hard time.

Thanks guys Mick
Wag62

Thanks guys still haven't changed the slave and hose need to get a hose made as repco and rare spares don't have them.
New hose will be ready on Monday now will give a verdict when replaced.
Thanks for the imput.
Wag62 Mick

Thanks Jake and yes my pedel is hard to push in also.
I have a new slave cylander in the shed so will fit it and post the result.
Thanks mate
Wag62 Mick