Dave’s EK supercharged v6
Re: Dave’s EK supercharged v6
And in the a pillar bottoms 3/8”
FB ute fixer upper, EK van on rotisserie
FB ute fixer upper, EK van on rotisserie
getting my FB ute on the road
EK van on rotisserie
EK van on rotisserie
Re: Dave’s EK supercharged v6
Hosed everything out I recon there was about 1 kg of dirt but no sockets haha
[*]2 year project currently making its 3rd term
Re: Dave’s EK supercharged v6
Next piece ready to weld in
- Attachments
-
- 4B6CFAEF-069C-4529-ADBA-01A44914D3F2.jpeg (2.88 MiB) Viewed 862 times
[*]2 year project currently making its 3rd term
Re: Dave’s EK supercharged v6
looks a little thin around the sway bar mount,...
Re: Dave’s EK supercharged v6
Same as before. Plate just sitting in at the moment so it’s a bit low once I lift it and weld it, it will be good
[*]2 year project currently making its 3rd term
Re: Dave’s EK supercharged v6
Other corner now fully welded just need to grind back and clean up
Chassis strengthening plates tacked on ready to seam weld
Chassis strengthening plates tacked on ready to seam weld
- Attachments
-
- 839914C6-630D-4853-B32F-8571FA22A285.jpeg (2.76 MiB) Viewed 814 times
-
- 5D63A879-19A1-4E96-8167-B27EAD5A2064.jpeg (2.74 MiB) Viewed 814 times
-
- 3F128236-19C0-4BC7-9398-C10A9A1317FF.jpeg (3.08 MiB) Viewed 814 times
[*]2 year project currently making its 3rd term
Re: Dave’s EK supercharged v6
Good stuff Dave. Can you tell me what gauge/thickness the reinforcing plates are?
FB ute fixer upper, EK van on rotisserie
FB ute fixer upper, EK van on rotisserie
getting my FB ute on the road
EK van on rotisserie
EK van on rotisserie
Re: Dave’s EK supercharged v6
Not sure mate but I will measure for you this arvo
[*]2 year project currently making its 3rd term
Re: Dave’s EK supercharged v6
Sorry just checked. They are 3mm
[*]2 year project currently making its 3rd term
Re: Dave’s EK supercharged v6
Thanks Dave I guessed they’d be 3mm. Thinking about when I do my subframe after the main shell.
FB ute fixer upper, EK van on rotisserie
FB ute fixer upper, EK van on rotisserie
getting my FB ute on the road
EK van on rotisserie
EK van on rotisserie
Re: Dave’s EK supercharged v6
I originally had them welded to another front end but cut them off and put on the new one. Much better doing it this way as I originally welded them laying under the car…….never again
[*]2 year project currently making its 3rd term