fbekholden.com

Looks like going to be a lot of fun Taz

Sent from my SM-G781B using Tapatalk

Made a start on the air system today for the suspension.

Comin along nicely Taz. Have you got the suspension set up so you can dump it on the floor.?
Cheers
Mick

Started running the lines to the shockwaves. Need to get a few more fittings. I will also get two braided lines for the front shocks as these are mounted upside down so the fitting g is on the bottom of the strut.

Cool man

Sent from my SM-G781B using Tapatalk

62MLOO wrote: ↑Sun Sep 11, 2022 7:14 am Comin along nicely Taz. Have you got the suspension set up so you can dump it on the floor.?
Cheers
Mick

Aired out it should sit 50mm off the deck

Playing around with airlines. Managed to
run all lines inside the vehicle from the boot along the top of the tail shaft hump and out either side existing inside the front guards. Wiring will take the same route.

Dakota gauges are on their way from the good old USA, almost 5 month wait but they will be worth it.

Very nice Taz


FB ute fixer upper, EK van on rotisserie

Aired out and rolling and no those are not the wheels I am going to use.

Awesome work TAZ !!!

It some ways getting it on all fours is a bit of a milestone !!!

It will look superb and probably ride better than most cars of today.

Regards Greg

Low and behold…..


FB ute fixer upper, EK van on rotisserie

5 months wait to get these gauges. I reckon they will look great once mounted.

They are going to look very cool Taz

Okay, time to get some work done on the car. Gauges are now mounted to the dash. Plan is to get all the wiring and air suspension operational over the next week. Wish me luck.

I am hoping to get some wiring sorted on the rattler this week as well - not my favourite job