Page 1 of 1
FE -EK Floor pan Question.
Posted: Fri Jun 17, 2016 10:40 pm
by oz_ek
Would I be correct in assuming fe,fc,fb,ek all use the same floor pan,?...Complete from the firewall to the boot?
Re: FE -EK Floor pan Question.
Posted: Fri Jun 17, 2016 11:10 pm
by Blacky
Yes AFAIK , sedans and vans/utes/wagons are different however.
Re: FE -EK Floor pan Question.
Posted: Fri Jun 17, 2016 11:32 pm
by oz_ek
Thanks, I just looked in the master parts catalogue and it lists front pan #12.972, it would appear this pan fits all fe-ek?... Unfortunately there's no listing for the centre section (rear) floor....And yes, looking at the very rear of the pan across the ute, wagon, sedan, etc, different location of the fuel tank and the spare wheel well in the sedans and so on.
Re: FE -EK Floor pan Question.
Posted: Sat Jun 18, 2016 11:38 am
by Errol62
There are some cosmetic differences in the front upper near join to firewall between FB and EK. I stress that they are cosmetic. The EK autos are different again of course. Can post comparison photos of you are interested or have a look at my EK van build thread.
Sent from my iPhone using Tapatalk
Re: FE -EK Floor pan Question.
Posted: Sat Jun 18, 2016 8:20 pm
by oz_ek
Cheers Clay,
It's the centre/rear section from Fe to Ek that I'm interested in.
Re: FE -EK Floor pan Question.
Posted: Sat Jun 18, 2016 11:07 pm
by Errol62
FE-FB sedans are identical. EK manual minor difference at ps trans hump join to firewall but interchangeable. Ditto for other body types I believe.
Sent from my iPhone using Tapatalk