Posted: Sun Jul 05, 2009 11:30 am
OOOOOO NO i snaped mine ..i did it very slow ...and even use the same tools ...anyone got a spear...thanks
Come on its not that bad its only a EKDA FLETCH wrote:anyone got a spear...thanks
fbekholden.com
FB-EK Holden Car Clubs of Australia
https://www.fbekholden.com/forum/
removing Special badge from a glovebox door
Page 2 of 2
Posted: Mon Jul 06, 2009 6:51 pm
Posted: Sun Apr 04, 2010 11:36 am
was it just the ek's that had this special badge? 
Posted: Sun Apr 04, 2010 7:06 pm
Yes 
Posted: Sun Apr 04, 2010 7:32 pm
ok cheers, ive got one and was going to put it on my FB van but better not degrade it with ek stuff!!! 
Posted: Sun Apr 04, 2010 7:53 pm
Brett, I know someone that wants one! Trev 
.
.Re: removing Special badge from a glovebox door
Posted: Fri May 30, 2014 7:46 pm
I managed to get mine off today using some good old WD40 and Luke's method, so cheers. The only question I have is can anyone tell me how to get those retaining clips out that hold the badge on?????
Re: removing Special badge from a glovebox door
Posted: Sun Jun 01, 2014 8:08 pm
Hi Viper
If you are putting the badge back on just leave the clips there. If you are wanting to smooth over then punch the clips in.
Stewart
If you are putting the badge back on just leave the clips there. If you are wanting to smooth over then punch the clips in.
Stewart
Re: removing Special badge from a glovebox door
Posted: Sun Jun 01, 2014 8:33 pm
Thanks Stewart,parisian62 wrote:Hi Viper
If you are putting the badge back on just leave the clips there. If you are wanting to smooth over then punch the clips in.
Stewart
I going to have to punch them in then. Do you know where I can get some replacement ones from then? Or can anyone else tell me? I'm own in Melbourne, so do Rarespares stock them?