Has anyone got a plastic reservoir for the original clutch master cylinder in good condition they are willing to sell? I have a resleeved master but only a metal can which I would like to replace with a clear tank.
Thanks, Brett
Plastic reservoir for original clutch master
Plastic reservoir for original clutch master
Sucker for a rusty bomb
Re: Plastic reservoir for original clutch master
Reckon I’ve got a spare one you can have Brett. I’ll have a look.
FB ute fixer upper, EK van on rotisserie
FB ute fixer upper, EK van on rotisserie
getting my FB ute on the road
EK van on rotisserie
EK van on rotisserie
Re: Plastic reservoir for original clutch master
Thanks Clay. I have a few but they are all for a larger diameter thread.
Sucker for a rusty bomb
Re: Plastic reservoir for original clutch master
Ok, I'll make sure it is the smaller diameter one.
Sent from my SM-G781B using Tapatalk
Sent from my SM-G781B using Tapatalk
getting my FB ute on the road
EK van on rotisserie
EK van on rotisserie
Re: Plastic reservoir for original clutch master
All the reservoirs I have are the same thread. They fit this original HD clutch master so these are the later type.Inside thread diameter is 1 1/8"
Sent from my SM-G781B using Tapatalk
Sent from my SM-G781B using Tapatalk
getting my FB ute on the road
EK van on rotisserie
EK van on rotisserie
Re: Plastic reservoir for original clutch master
There was an aftermarket plastic reservoir (PBR?) for the early master cylinders. They're a bit hard to find, though . . .
Rob
Rob
Re: Plastic reservoir for original clutch master
Thanks for looking Clay. Hopefully something will turn up. Part of a few changes to Project 2
Sucker for a rusty bomb
Re: Plastic reservoir for original clutch master
I guess you are running the earlier type Brett.
FB ute fixer upper, EK van on rotisserie
FB ute fixer upper, EK van on rotisserie
getting my FB ute on the road
EK van on rotisserie
EK van on rotisserie