wanting new floor pans
wanting new floor pans
any one know of good place to get floor pans for ek sedan front and rear both sides thanks for any help thanks from gazza
Last edited by gazza116 on Tue Jul 11, 2017 1:44 pm, edited 1 time in total.
Re: wanting new floor pans
Either Taylor's Panels ph: 07)32821818 or your local Rare Spares should be able to help you out.
Might be a good idea to edit out your phone number from a public forum!....Never know what type of freak could call!
Re: wanting new floor pans
Hi Gazza
Definately Taylors for the front ones unfortunately he does not make the rear ones and you will have to go to rares for them although I don't like them much I had to by them.
Regards
Neil H
Definately Taylors for the front ones unfortunately he does not make the rear ones and you will have to go to rares for them although I don't like them much I had to by them.
Regards
Neil H
Member of WA FB/EK Car Club
Frankenstein EK V6 Ute
FB Station Wagon Project
1950's Commer Light Truck (2.5 Ton)
Frankenstein EK V6 Ute
FB Station Wagon Project
1950's Commer Light Truck (2.5 Ton)
Re: wanting new floor pans
thanks for the help guys
Re: wanting new floor pans
Welcome to the forum Gazza, Taylors was the mob I was trying to remember the name of on the weekend
Got a bit of CRAFT disease ............
Got a bit of CRAFT disease ............
When you're faced with an unpleasant task that you really don't want to do, sometimes you just have to dig deep down inside and somehow find the patience to wait for someone else to do it for you.
Foundation member #61 of FB/EK Holden club of W.A.
Foundation member #61 of FB/EK Holden club of W.A.
- bumper
- Posts: 717
- Joined: Mon Dec 31, 2007 10:07 am
- State: TAS
- Location: Devonport tasmania
- Contact:
Re: wanting new floor pans
Used all 4 rares ones in my green wagon, fitted no drama
wanker????
I'd rather consider myself as an "owner operator"!!
FBEKHOLDENFANS page
https://www.facebook.com/groups/253705454864/
I'd rather consider myself as an "owner operator"!!
FBEKHOLDENFANS page
https://www.facebook.com/groups/253705454864/
Re: wanting new floor pans
Also used the rates one, no issues with them.
Speed and Style........... One day I'll get the speed bit.
Re: wanting new floor pans
I recently did the floor pans on my FB and contrary to what the other posts say, I found that the front pans which I bought from Taylors DID NOT FIT! both wher 8 mm too narrow and required a lot of rework in other areas _ very disappointing. However the rear pans which I got from Rare Spares just dropped right in with just a little trimming. Cheers, Fraze.
Re: wanting new floor pans
The hydramatic front pressings are different over the north south bracing sections. I haven't seen anyone catering these. I have the Taylor's panels but yet to fit. The holes in my floor are bigger than the replacement panels in any case.
Cheers
Clay
Sent from my iPhone using Tapatalk
Cheers
Clay
Sent from my iPhone using Tapatalk
getting my FB ute on the road
EK van on rotisserie
EK van on rotisserie