Hi all,
Anyone else have trouble with the original grey motor exhaust manifold leaking, due to corrosion / warping. It looks to be leaking with a new gasket, along the top of the exhaust manifold. Can you machine them flat again?
Regards
CC
Exhaust manifold
-
In the Shed
- Posts: 1881
- Joined: Wed May 16, 2012 10:18 pm
- State: SA
- Location: South Australia
Re: Exhaust manifold
Hi CC,
Yes had that problem. Tried new gasket then tried copper heat gasket silastic which just blew out after a short run. You can easily fix it yourself. See my post on page two. Post up any other questions you might have.
http://www.fbekholden.com/forum/viewtop ... 8&start=15
Regards
Stephen
Yes had that problem. Tried new gasket then tried copper heat gasket silastic which just blew out after a short run. You can easily fix it yourself. See my post on page two. Post up any other questions you might have.
http://www.fbekholden.com/forum/viewtop ... 8&start=15
Regards
Stephen
A day in the shed beats a day at work!
Re: Exhaust manifold
Thanks Stephen,
Got to find time to work on the EK
Got to find time to work on the EK