fbekholden.com

Hi Brett instead of stealing Sneezy's thread I thought I would bring this over here. That heater tap has an ECU will it only run with the Vintage Air unit or could I just ditch the ECU and run an open or closed switch on the water tap. Looks good value and might solve some problems but maybe need to...

Now that's a pretty neat little bit of kit most of the modern ones I've seen run on vacuum.

Thanks for posting Brett

Hey Brett you got a photo or details on the electric tap

Barney's looking great there Brett and I love the FC beside him

Hi Shane'o Supercheap do sell steering wheel pullers I purchased one some years ago and it does the job just fine mate.

Stop Clay my sides are hurting from laughing so much mate.

You must mean to 2026 Nats and even then I'm skeptical

Hi Sneezy, there is supposed to be a flap on the plastic bit that covers the core I assume this was so you could keep it shut and the hot air would go to the demister or open and the hot air came into the cab, yours is missing the flap, I have one and it looks like the heater lever would have had a ...

Yesterday I got into the rear piece I had started, found that there is actually three pieces one on top of each other and they had spot welded all three at once, so once I removed the top one I had to redrill the same spot welds, I’ve made up the two pieces but they have to wait till next time. IMG_...

You crack me up Harv

Apologies Harv I went to sea when I was 17 and the ship I was on had a 2 cylinder Lister emergency air compressor, if you got the cranking wrong when you dropped the decompression cocks it would throw you into the bulkhead :lol: :lol: :lol: :lol: Quite a few guys had also broken thumbs by not gettin...

Hey Brett are you bring Barney over for the Nats???

$90K

I've heard that Blacky, the EK beside the Reverend must have been almost completely gone then because I think all of the tinworm must have been hungry and looked for greener pastures looked at the Rev and thought why not we will give it a go

Both Rear Quarters inside and out now done a bit of body work and they will be ok I suppose :lol: :lol: IMG_2018.JPG Moved to the very back now, more metal worm :roll: IMG_2020.JPG Cut it out but there is another piece that rolls inside at the bottom that is also stuffed on the top edge inside so I ...

Passenger side rear quarter finished used the wet rag and tack tack still got a little shrinkage near the back end but maybe that was cause the gap between the two pieces may not have been wide enough, anyway doing the best I can.
Now to tackle another area at the back before going to outer sills.