fbekholden.com

Any updates, Fishyweare? frats, Rosco been a slow weekend had to clean the shed and make room for the wagon.built a trolley to put FB van on as it's been sitting on a rotisserie taking up all the room in the shed so it's getting pushed into the corner. prepped the tailgate and the cowl , bloody ter...

well it's been a slow week with inner tailgate skin had nothing but dramas with the Tig so out came the mig was concerned with distortion so it was a slow process but happy with the finished result.just need to run a bit of filler over the edges.

Rosco
not at all knowledge is priceless I encourage comments it makes one stop and reevaluate the process.
Cheers

well had a real hard time removing bottom hinges from tailgate stuffed the tip on my impact screwdriver these screws were just not going to budge soaked them for a few days still nothing so drilled a hole through centre which allowed enough heat to whack the impact driver on them again came they loo...

Cheers all good found it.
was going 2 pac that was my problem will have to get it eye matched was hoping someone else may have had it mixed in 2 pac.
for anyone else who is looking the code has DO in front of the last 4 digits.
Enamel and acrylic Lacquer.
Cheers
Paul

Has anyone got the new codes for this having problems getting it mixed up.
cheers
Paul

There were a heap of aftermarket grey motor timing gears made, mostly unbranded. I've posted the ones from John Brown's collection here: http://forums.fxfjholden.com/viewtopic.php?f=16&t=5068 None like yours though. Cheers, Harv Harv might be a secret nasco protoype. will have a look at John's ...

I have an unused fibre timing gear .
just wondering if anyone knows the brand of this? constructed of metel with fibre outer.
has no markings on it other then timing dot.

Cheers
Paul

well i've just worked out why my steering wheel is bent forward , and here i was thinking what a great idea as really comfortable to drive with the wheel not sitting right on top of you. removed hood lining to find a surprise ,the top section of windscreen has been replaced and have also noticed the...

at last iv'e fond some rust .well thats not too bad .

Fishy was there an oil supply problem with the engine? Craig i don't believe so when i took it to the engine builder his thoughts were at some stage oil must of been low at some point of the engines lifetime , as all bearings showed a fair bit of wear sump was pretty clear of sludge thinking that m...

does anyone know if these seals are in the full rubber kits? noticed also there is a gasket between guard and body as well.

windscreen out and was expecting to see some horror but all good bit of surface rust on lip but nothing to worry about. YET.

parisian62 wrote:

really happy with everything atm all coming apart so easy lets hope it's like that putting it back together

Like a big meccano set Putting it back together is OK just don't rush it.

Yep everthing bagged ,marked and pics taken

really happy with everything atm all coming apart so easy lets hope it's like that putting it back together inside the panels are really clean