fbekholden.com

I think I was a little careful on the depth of the drilling, I drilled through the alloy handle and about 2-3 mm into the steel shaft - then tapped the handle. I added the grub screw. And checked the depth every 1/2 turn of the Allen key until it was super solid, checking the lock mechanism at every...

And charges $495 for them


Sent from my iPhone using Tapatalk

See here. Added a grub screw.


Sent from my iPhone using Tapatalk

It looks
Like a grub screw may do the trick

So drill and tap a small hole ? Add a grub?


Sent from my iPhone using Tapatalk

Can this be repaired?


Sent from my iPhone using Tapatalk

Ok. So I got the part out and the upper part just spins on the shaft


Sent from my iPhone using Tapatalk

Appreciate your help. I’ll give it a crack over the weekend.


Sent from my iPhone using Tapatalk

Do you think its the inner gear that’s stripped?


Sent from my iPhone using Tapatalk

Good afternoon! Getting back to work on Monty today after a Christmas hiatus. I replaced all the door and tailgate seals and now I cannot open the rear tailgate the handle just spins around. Also the drivers inner door handle same problem. Have I damaged parts because the seals were tight? It did ta...

Dragging this up again. Purchases all new seals, same issue. Water all over the interior boot area. https://uploads.tapatalk-cdn.com/20220629/357857d75bafc7bb43512a873db6b246.jpg Did anyone solve this? I have some polymorphic plastic I can mock up a piece? Would be an easy mold to make Sent from my ...

Blacky wrote:yep , looks correct to me

Much appreciated. Stated first time as usual


Sent from my iPhone using Tapatalk

Abs this And this


Sent from my iPhone using Tapatalk

Hey !
I am putting all my bits back together, is this looking correct for my locations?
Sent from my iPhone using Tapatalk

Thanks for the confirmation!
It pulled up a little, now probs less than a washer gap. I don’t want to take it back out as it fought me hard going in! I might seam seal around it.


Sent from my iPhone using Tapatalk

Thank you. I think the bolt had a layer of crud on it when we were taking it out, I didn’t notice a gap. Now it’s all clean I just wanted to make sure I wasn’t missing a component. There’s a 1mm gap between the bolt head and outer skin of the torque box now. Yes the whole area is now super strong. T...