fbekholden.com

Can anyone advise if a "Steering connecting rod" off an EH/EJ would suit the FB ?
i only require the draglink tube
by picture they look the same but unsure of measurments

Length = 170 mm
Width = 47.5 mm

if you are really stuck i can loan you one as i dont have enough spares to sell
im in boronia 40k's east of melb home after 5:30

close up ?

A hacksaw blade is a good tool to get the points approxamate
specks for the points are 0.015 in. from memory
remember points effect timing, timing dont effect points , so set the points first then check timing.
and if you change the points gap recheck your timing.

Thanks for that, i does look like someone was testing the No. 3 stamp to see if it works (or half of "666" spawn of satan)
but if anyone know what the 333 reference is i would apprecieate.

Besides the rust holes in the cabin floor and passenger sill she'e in pretty good shape i aquired it from a bloke in launching place who towed it from shepparton where its been sitting for 20 years, thats the only history i could get. any idea what top = 333 ? couldn't find any reference to it in th...

couldn't resist "buy it now" http://i788.photobucket.com/albums/yy161/control_alt_del/P9080013.jpg body ident http://i788.photobucket.com/albums/yy161/control_alt_del/P9080010.jpg Engine http://i788.photobucket.com/albums/yy161/control_alt_del/P9080002.jpg Chassis http://i788.photobucket.c...

Must say a big thank you to the FEFC Car Club for the auction and pie night
Had a good time and cheaper than a night at the pokies

the number plate's a cracker ITSAFB

I have a set of mags that are stamped 13 6½ JJ I would equate that to 165/xx 13 is this correct ? The current tyres are 205/50 13 & 215/50 13 and I have measured the width of the rim at 195mm (outside), I would assume that the actual measurement should be the inside measurement that I would esti...

put the rear end up on axel stands and see if you can locate that way
whats your feeling? running gear noise or body rattle ?

I Have a rear view mirror that you can have (avarage condition)

Bump

Hi Cruze The impedance of the Radio should match the impedance of the speaker to get maximum power transfer you could use a 12 or even an 8 ohm speaker but the current out of the radio would be higher, unless you have the radio at full volume this is quite acceptable, but if you do turn it up to 11 ...